View Single Post
Old November 20, 1999, 10:14 PM   #2
WalterGAII
Junior member
 
Join Date: November 7, 1999
Posts: 1,516
If you're using the seating/crimp, die, then just do like the instructions say. Set the seating depth first, then screw the entire die in a quarter turn or so, for a firm crimp. (Remember to turn out the seating knob the same amount)

If you use the Factory Crimp Die, which I highly recommend, you seat in one stage, and crimp/post size with the Factory Crimp Die. The Factory Crimp die does use a knob to control the amount of crimp.

If you're going to load handgun ammo on a single stage press, the Lee Speed Die is really nice. One die body does everything.

[This message has been edited by WalterGAII (edited November 20, 1999).]
WalterGAII is offline  
 
Page generated in 0.04015 seconds with 8 queries