View Single Post
Old August 31, 2017, 06:48 AM   #4
Don P
Senior Member
 
Join Date: December 17, 2005
Location: Swamp dweller
Posts: 6,187
As Jim stated read the rules before buying equipment at USPSA.org.
Quote:
I am looking at buying a trex arms ragnarok holster which will mount to my safariland UBL with a leg strap. I'm looking at the light compatable model with a streamlight tlr 1. Is the leg strap, and light allowed on the 17 when shooting production?
No, the holster is not allowed Appendix D4,
Handgun Rules, February 2014 Edition
APPENDIX D4 — Production Division
1 Minimum power factor for Major Not applicable
2 Minimum power factor for Minor 125
3 Minimum bullet weight No
4 Minimum bullet caliber / cartridge
case length
.38 cal. / 9x19 mm (0.354” x 0.748”)
5 Minimum bullet caliber for Major Not applicable
6 Minimum trigger pull No
7
Maximum size
Handgun and all magazines
(revolvers are exempt)
Yes, handgun with empty magazine inserted
must fit wholly within a box with internal
dimensions of 8 15/16” x 6” x 1 5/8” (tolerance
+1/16”, -0”) (8.938”x6”x1.625”)
(227.01mmx152.40mmx41.28mm)
8 Maximum magazine length See # 7
9 Maximum ammunition capacity Yes, maximum 10 rounds loaded in any magazine
after the start signal
10 Max. distance of handgun and
mags/speed loaders from inner
side of belt
Handgun and Mags - 2”

11 Rule 5.2.3.1 applies Yes
12 Restriction on position of holster
and other equipmen
t
(revolver speed loaders, moon clips
are exempt)
Yes, see Appendix E3
13 Optical/electronic sights permitted No, notch and post only
14 Installed flashlights permitted No
15 Compensators permitted No
16 Barrel ports permitted No
17 Slide ports permitted Yes, on factory-original approved models
18 Maximum weight Yes, 2 ounces with empty magazine inserted
over weight listed on approved pistol list
19 Handgun specific approval for
Division
Yes - see Special Conditions
20 Holster and magazine holder
restrictions
•Suitable for everyday use. “Race gun” type
holster prohibited.
•May not be manufactured or cut lower than,
and must cover the slide up to, 1/2” below
the ejection port (belt slide “Yaqui” type
holster exempt).
•Revolver holsters open no lower than
halfway down the cylinder.
•The drop offset type holster is allowed in
production Division as long as the heel of
the butt of the gun is above the belt per
5.2.7.2 and the rest of the criteria are met.

•Each magazine must be contained individually
within the magazine pouch. Magazines may not be
retained through magnetic means.
I have place answers to your question in bold text
__________________
NRA Life Member, NRA Chief Range Safety Officer, NRA Certified Pistol Instructor,, USPSA & Steel Challange NROI Range Officer,
ICORE Range Officer,
,MAG 40 Graduate
As you are, I once was, As I am, You will be.
Don P is offline  
 
Page generated in 0.02790 seconds with 8 queries