View Single Post
Old December 7, 2019, 11:30 AM   #11
turtlehead
Senior Member
 
Join Date: October 20, 2015
Location: Phoenix, AZ
Posts: 1,203
Tankist,

I went through the same thing with mine. Was a bit surprised at the force needed to remove the pin. All I can say is hit it like you mean it.

In my case the extractor was the issue. Replaced it with a Volquartsen extractor and the gun has been 100% ever since. And the pin goes in and out now just fine, too.

Here is a link to the old thread. https://thefiringline.com/forums/sho...d.php?t=588655

Look at the picture in post #25. The extractor wasn't gripping down at the junction between the case body and rim. Maybe you have the same issue. The stock 41 extractors are very poor quality compared to the Volquartsen. Compare yours to this pic. https://www.midwayusa.com/product/1016433722

Hope that helps.
turtlehead is offline  
 
Page generated in 0.04782 seconds with 8 queries