View Single Post
Old November 22, 2019, 09:01 AM   #2
4V50 Gary
Staff
 
Join Date: November 2, 1998
Location: Colorado
Posts: 20,642
Get a 2 x 4 and drill a small hole in it. This becomes your bench-block. Place the slide on top of it such that the pin can be driven down into the hole.

Be sure you use a straight punch. Tapered punches will get stuck. General rule (but there are exceptions) pins are driven from the right side out towards the left.
__________________
Vigilantibus et non dormientibus jura subveniunt. Molon Labe!
4V50 Gary is offline  
 
Page generated in 0.02779 seconds with 8 queries