View Single Post
Old March 24, 2013, 04:51 PM   #3
BoogieMan
Senior Member
 
Join Date: April 4, 2012
Location: South Jersey
Posts: 2,217
Am I going to save anything by removing old barrel and installing new? Or will it have to be re-moved again to finish chamber/headspace?
Any recommendations on a smith that can do a nice job and do a nice re-blue"?
How about determining the contour and length for the new barrel? I think I will stick with 30-06. I would like to use it to see how far I can reach out. I was able to shoot a decent ba 30-06 this weekend and found out im capable of sub 1" groups. If I had a rifle that would make those groups I think I could stretch out a bit.
__________________
Concentrated power is not rendered harmless by the good intentions of those who create it.
Milton Freidman
"If you find yourself in a fair fight,,,
Your tactics suck"
- Unknown

Last edited by BoogieMan; March 24, 2013 at 05:06 PM.
BoogieMan is offline  
 
Page generated in 0.03332 seconds with 8 queries