Grey_Lion
Quote:
I'm not seeing anywhere that anyone here has taken out a caliper and measured the brass or the primers. You swage, chamfer, drill, etc your brains out but no-one has stopped to actually measure the brass or the primers to see if one or both are off....... Why?
|
OK, good point so using your calipers measure your primer OD (Outside Diameter):
Using the same caliper measure you pocket ID (Inside Diameter):
This should give you an idea as to how well you can expect an interference fit when you seat the primers. The tolerances for both primer width and cup width have already been posted.
Note: The images posted are mine, anyone can feel free to use them or lift them. The images are linked to a domain which belongs to me so there is no "hot-linking" going on or ripping off another's images.
Ron