View Single Post
Old October 10, 2012, 08:28 PM   #2
mrawesome22
Senior Member
 
Join Date: November 9, 2005
Location: Ohio, Appalachia's foothills.
Posts: 3,779
Case capacity is better measured by filling a fired case with water (no miniscus), weigh, dump water out, weigh again.

Stick powders can, and do, vary fill ratio depending on height and rate of speed the powder is dumped.

Fill a case with Varget, cover the mouth with your finger and give the head a few taps on a hard surface. You will find that the powder level has gone down substantially.

sudo passwd root
mrawesome22 is offline  
 
Page generated in 0.02654 seconds with 8 queries