Make certain that the pin is out. Turn the grip frame upside down, clamp smooth vise jaws hard onto all of the ejector that protrudes. Then grasp the frame solidly and pull upward while slightly rocking back and forth lengthwise of the ejector as you loosen and pull the frame up off the solidly held ejector.
If it won't loosen, some genius has appllied LocTite to the holding pins and you have to apply heat to the protruding part of the ejector. Moderate heat is called for. Then clamp it and again try to remove the frame from the solidly grasped ejector.
Some gunsmiths use a toolmaker's vise to clamp the ejector itself and rock as they lift. Don't rock it side to side, only fore and aft.
[This message has been edited by John Lawson (edited December 30, 1999).]
|