[QUOTE] just to clarify though..... The 45/45/10 is 45 Alox 45 Johnsons and 10 mineral spirits???? is that right ? [QUOTE]
Yes.
Tumble lubing is not "complicated" at all. I actually is about as simple a lubing process you can get.
One thing I have found is that the Lee sizing die can under size the bullets. My 45 bullets should be .451, but actially came out .450-.4505. Always check your sized bullets for proper fit.
If your bullet come out to small you and open up the die in just a few minute.
Take the die out of the press.
Remove the lock ring.
Wrap a dowel rod with some emery paper, 400grit to start, 600+ to polish.
Insert the rod into the die and roll it across the table.
Check internal diameter often as the die is soft and it doesn't take long.
Here is a few videos.
http://www.youtube.com/watch?v=6Oo94tT8_-k
http://www.youtube.com/watch?v=xG2MFQL8oLU
http://www.youtube.com/watch?v=CduXYE_ISVU
EDIT: Wrong bullet diameter.
My 45 bullet should be .452, they sized at .451-.4515. Sorry.