View Single Post
Old September 4, 2021, 11:07 PM   #7
FoghornLeghorn
Senior Member
 
Join Date: September 2, 2011
Posts: 923
Quote:
I assume, when you say "the gap is too tight" and primers you are talking about the gap at the rear of the cylinder, not the barrel cylinder gap.
The thinnest feeler gauge I have is .005 inch. It won't go into the gap between barrel and cylinder. It also will not go between a factory unfired cartridge loaded in the cylinder and the breech face.

There's definitely something off. I bought the gun used and haven't owned it that long.
FoghornLeghorn is offline  
 
Page generated in 0.02447 seconds with 8 queries