View Single Post
Old September 4, 2021, 06:33 PM   #6
bedbugbilly
Senior Member
 
Join Date: November 19, 2009
Posts: 3,228
Where is it binding - rear of cylinder or face of cylinder? If you are shooting your reloads - do they fall within the accepted COAL? I know you are shooting light loads - but are you roll crimping or taper crimping? If backed out primers are the "real" culprit - then you need to load them a little heavier - a RH should certainly be able to handle between minimum and maximum load for the powder/bullet combination you are using regardless if jacketed or lead. Are you loading at least the minimum recommend charge for your powder/bullet combination?
__________________
If a pair of '51 Navies were good enough for Billy Hickok, then a single Navy on my right hip is good enough for me . . . besides . . . I'm probably only half as good as he was anyways. Hiram's Rangers Badge #63
bedbugbilly is offline  
 
Page generated in 0.02757 seconds with 8 queries