|
mongrel66,
Iv'e had two Poly M14s one I had rebuilt by Fulton Armory(great rifle) and have never had a problem w/slamfires. I did have a doubling problem from a used rifle but that was from a bad trigger job which was an easy fix. I've also loaded about 90% of the ammo for these, the key is case prep(proper sizing, primer pocket uniforming and primer seating, etc.). I uniform all primer pockets on all my rifle brass, you only need to do this once. Like a previous poster mentioned before, a high primer will cause this in a hurry. I'm by no means an expert but I've yet to see a slamfire from factory loaded ball or match ammo with an M1A or M14 type rifle, this is usually traced back to the reloading bench. If you shoot factory ammo I doubt you'll have a problem but if anyone out there has seen this with factory ammo feel free to ring in. This is only based on my experiences and of some friends(small sampling).
Mouse Gun
|