The Firing Line Forums - View Single Post

SKULLANDCROSSBONES65 · May 23, 2009, 10:07 PM

G'day and welcome. If you dont have a bullet puller you could try a make shift one. Get a piece of pipe/tube that the case will fit into but the casing holder will not. Put the bullet into the pipe (hold it in place with some tape) hold the pipe strait up in the air (Bullet end up) then tap the bullet onto a hard surface. Remember the powder will spill and need to be cleaned up/ destroyed. You may need to 'tap' it a couple of times.

May 23, 2009, 10:07 PM	#4
SKULLANDCROSSBONES65 Senior Member Join Date: August 19, 2008 Location: Far Nth Wst QLD Australia Posts: 992	G'day and welcome. If you dont have a bullet puller you could try a make shift one. Get a piece of pipe/tube that the case will fit into but the casing holder will not. Put the bullet into the pipe (hold it in place with some tape) hold the pipe strait up in the air (Bullet end up) then tap the bullet onto a hard surface. Remember the powder will spill and need to be cleaned up/ destroyed. You may need to 'tap' it a couple of times. __________________ If you're not confused, you're not trying hard enough! When you're confused, I'll try to use smaller words!!!