The Firing Line Forums - View Single Post

ryan1985 · February 22, 2013, 11:27 AM

Ok that makes me feel better because the DA functions just fine and is capable of rapid fire without a hiccup. I didn't actually touch the mechanism at all when I took the plate off but I will check the hammer block like you said. All I did was blast the inside real good with a can of powder blast and put some slip2000 on the moving parts. I've bought spare parts for my ar on brownells and midway before but haven't looked for parts for my revolver yet. I do remeber back in 2009 I lost one of the side plate screws and had a hard time finding one and could only get it from taurus.

It's odd I can cock and de-cock it to my heart's content and it doesn't jam it's only after firing a round that cause the SA to jam up.

February 22, 2013, 11:27 AM	#12
ryan1985 Member Join Date: July 22, 2012 Posts: 24	Ok that makes me feel better because the DA functions just fine and is capable of rapid fire without a hiccup. I didn't actually touch the mechanism at all when I took the plate off but I will check the hammer block like you said. All I did was blast the inside real good with a can of powder blast and put some slip2000 on the moving parts. I've bought spare parts for my ar on brownells and midway before but haven't looked for parts for my revolver yet. I do remeber back in 2009 I lost one of the side plate screws and had a hard time finding one and could only get it from taurus. It's odd I can cock and de-cock it to my heart's content and it doesn't jam it's only after firing a round that cause the SA to jam up.