View Single Post
Old March 11, 2011, 08:52 PM   #2
Pahoo
Senior Member
 
Join Date: February 16, 2006
Location: IOWA
Posts: 8,783
You mention that you have had gunsmiths look at it and they could not fix it? That doesn't make sense. As far as seals, are you tallking about the piston rings and rubber O-Ring? Replace the O-Ring and make sure the steel ring and cup, are not stuck or hanging up. I once bought a barrel that had a set of rings stuck hard, in the barrel cylinder. Also make sure your barrel ports are clear and clean. But gees, that smiths should have caught this. I've owned two of the LT-20's and they were sweet. So much so, that I sent them on to a better home. ....


Be Safe !!!
Pahoo is offline  
 
Page generated in 0.02535 seconds with 8 queries