View Single Post
Old April 2, 2014, 01:21 PM   #12
Senior Member
Join Date: August 25, 2008
Location: Potatoes and Hops
Posts: 11,138
I really don't think you'll get around the bulge problem. It's a design issue, not something that can really be avoided with component selection.

And if your current load is running clean, I wouldn't change powders.
As Unclenick mentioned - most powders run fairly dirty in 9mm, until you get the pressure up (approaching or at max charges).

If you do want to try something else, my suggestions would be:
(Not necessarily making burn rate a priority)

True Blue (possibly a bit slow for 115 gr plated loads)
Power Pistol
Don't even try it. It's even worse than the internet would lead you to believe.
FrankenMauser is offline  
Page generated in 0.02929 seconds with 8 queries