View Single Post
Old January 6, 2013, 10:22 PM   #6
Nanuk
Senior Member
 
Join Date: January 2, 2005
Location: Where the deer and the antelope roam.
Posts: 3,082
Your brass is fine until it starts splitting. With a revolver it is better supported than any semi auto and you get your strength from the cylinder, not the brass. I would polish the chamber.

Are you cleaning your brass when you reload it? Are your chambers clean? Do freshly sized case go in easy? I would think that if they were too long they would be hard to fully insert into the chamber.
__________________
Retired Law Enforcement
U. S. Army Veteran
Armorer
My rifle and pistol are tools, I am the weapon.
Nanuk is offline  
 
Page generated in 0.03450 seconds with 8 queries