View Single Post
Old December 25, 2008, 05:42 PM   #5
kraigwy
Senior Member
 
Join Date: June 16, 2008
Location: Wyoming
Posts: 11,061
Anything is possible if not practical. You can do it, get a trim die, cut it off, put it in a case trimmer for the finish cut. Then you need a reamer for the inside of the case, the web is too thick on ''06 cases. Its time consuming, and a pain in the butt.. I did it making .41 Datonics cases. I have a reamer for the Datonics but its a bit too big for the ACP.

The question is, since 45 brass is so much cheaper the '06 brass is WHY.

If the answer to save money, YOU WONT. If the answer is just to see if you can do it I'd say GO FOR IT.

I could write a book on the crap I've done or tried to do, things that made no sinse what so ever, I mean some really dumb ideals, but I've enjoyed every minute of it.

PS: When you're through with that project try making your own reloading dies, or whats more fun, cast bullet molds.

Don't ever stop experimenting, but do be careful, Nothing says safty like a Lead Sled and a long string.

If people were a afraid to try stuff, we'd still be throwing rocks.
__________________
Kraig Stuart
CPT USAR Ret
USAMU Sniper School
Distinguished Rifle Badge 1071
kraigwy is offline  
 
Page generated in 0.03117 seconds with 8 queries