View Single Post
Old March 31, 2018, 09:23 AM   #7
Slinky Pickle
Junior Member
 
Join Date: March 28, 2018
Posts: 5
The front sight is obviously something that someone through on recently and never shot it afterwards because at 25 yards it's 1.5 feet high. In the picture below I finally figured out what was going on and aimed very low. There was a 1/16" wooden shim under the rear sight so I removed it. The sight didn't appear to move much but I fired it again anyways. The top two holes are with the shim, the bottom two without. I am utterly amazed that this thing can shoot that straight given the condition of the bore.

I'll try a 1/2" front sight and lower the rear as much as possible and try it again. It looks like there's hope yet for this ol' girl.

Slinky Pickle is offline  
 
Page generated in 0.02909 seconds with 8 queries