The Firing Line Forums - View Single Post

grubbylabs · December 4, 2011, 04:44 PM

Well as you have read on the other site I am waiting for it to get back from the smith before I can work do any thing with it. I have some new powder for my 300 win that I have work up. I have found a good low speed powder for it, but to get the full benefit of the powder I am going to try some reloaded 22 and see if I can boost the speed and still get the groups I am now.

Plus I just got the other mold for my 45 auto. It is basically the same bullet I was shooting before, but I had Tom remove the shoulder. I suspect that there wont be much of a difference if any at all but I figured I would start over again any how.

Plus I still have a box of 50 150 grain soft points that I did to work up a load for my 308. They are all marked at what charge they are I just need to shoot them and see which ones perform.

I know I have it rough.

December 4, 2011, 04:44 PM	#4
grubbylabs Senior Member Join Date: October 11, 2009 Location: Hansen Idaho Posts: 1,465	Well as you have read on the other site I am waiting for it to get back from the smith before I can work do any thing with it. I have some new powder for my 300 win that I have work up. I have found a good low speed powder for it, but to get the full benefit of the powder I am going to try some reloaded 22 and see if I can boost the speed and still get the groups I am now. Plus I just got the other mold for my 45 auto. It is basically the same bullet I was shooting before, but I had Tom remove the shoulder. I suspect that there wont be much of a difference if any at all but I figured I would start over again any how. Plus I still have a box of 50 150 grain soft points that I did to work up a load for my 308. They are all marked at what charge they are I just need to shoot them and see which ones perform. I know I have it rough. __________________ * (Swinging club) Whack! whack! whack! * Nope, the old nag's still dead . (Capt Charlie)