View Single Post
Old August 4, 2012, 11:06 PM   #1
hammer58
Member
 
Join Date: July 29, 2012
Location: Lubbock, Texas
Posts: 45
.45 ACP Primer Question

I have just begun re-loading for my .45 ACP. I have been saving the brass from factory loads for a few months so that I would have brass to load as soon as I was able to purchase the dies. I noticed that some of the brass uses the Federal 150 primers (Large pistol primer) and some of the brass (Blazer and some Federal) use the small pistol primer.

I am loading 5 grains of Hodgdon HP-38 powder with a 230 gr LRN.

My question is this. What affect if any will using the small primers have on my loads?
hammer58 is offline  
 
Page generated in 0.03535 seconds with 8 queries