View Single Post
Old January 6, 2017, 08:45 AM   #133
Reloadron
Senior Member
 
Join Date: June 8, 2016
Location: Cleveland, Ohio Suburbs
Posts: 1,403
Kris, just keep at it with your approach and don't hesitate to post any pictures, progress or even steps backwards. While I am pretty much stuck till I get the PSU I want up here I want to try and wind a smaller coil and maybe find a core and wind a C core. Thinking back if we look at The Annie Cartridge Induction Heater using the C form inductor it looks to have only a few turns on each leg. Also looking at the image it is difficult to tell if they are using a center tapped coil design? I can't make it out anyway.
Little by little we can all add to this thread with any progress or lessons learned.

Ron
Reloadron is offline  
 
Page generated in 0.03111 seconds with 8 queries