Quote:
1) do you shoot alot of steel cased ammo out of the gun ? If so do you clean the chamber really well after ? As I'm sure you know steel cased ammo some times does not seal the chamber completely and you can get blow back and build up in the chamber . When the softer brass expands in the worm dirty-ish chamber the case can stick . This it what helps contribute to wearing of or broken extractors.
|
Never have used steel case, and wont unless SHTF, but thats different and trivial to think about haha.
Quote:
2) Bad extractor or spring
|
Leaning towards the spring. The case is always extracting correctly, it is just simply not ejecting out of the port and causing a jam.
Quote:
3) how did the cases look . I'm just getting in to reloading and I remember reading something about if the neck of the case expands to much it can stick to the (something ) I don't remember I want to say rifling but that does not sound right but there was something about the case expanding to much and sticking .
|
Cases looked fine. All factory ammunition. If its an ammo issue then my ammo just doesn't like Fiocchi or Hornady
Quote:
Extractor, extractor spring, insert and O ring. All are cheap, easy to swap out.
|
This is what I am leaning towards the most. Attached I provided the specific issue (albeit with live ammo) and the BCG
Updated Analysis is greatly appreciated
Edit: The first image was upside down, fixed it.