Thread: Jog My Memory!
View Single Post
Old June 29, 2020, 05:00 PM   #2
hank327
Senior Member
 
Join Date: February 26, 2005
Location: Texas
Posts: 106
S&W made the Model 13 .357 Magnum with a 3” heavy barrel and a round butt. It had fixed sights and the ejector rod was exposed like on the Model 10. In fact, a Model 13 with a 4” barrel looks just like the 4” heavy barrel Model 10 38 Spl.

They also made a 2 1/2” Model 19 with a round butt. However the 19 has an adjustable rear sight and the ejector rod is protected by a barrel shroud. These revolvers were K frame revolvers. I don’t remember them making a 357 snubbie back then with a 1 7/8” barrel.

But they might have as S&W back then would make just about any configuration if a distributor would order enough to make it worth their while.
hank327 is offline  
 
Page generated in 0.04838 seconds with 8 queries