Thread: Glossy wood
View Single Post
Old February 3, 2020, 02:01 PM   #13
SGW Gunsmith
Senior Member
 
Join Date: December 31, 2014
Location: Northwest Wisconsin
Posts: 276
To break the shine on the stocks surface, I prefer to wet sand the surface using #1200 wet-or-dry emery paper and a rubber sanding block using the same finish that I sealed the stock wood with. Works like this:





Wipe off the slight slurry left behind with a sheet of Bounty paper toweling and there will be no silver slivers left behind.
__________________
www.saronagunworks.com
SGW Gunsmith is offline  
 
Page generated in 0.03911 seconds with 8 queries