We use a hand crank style sight pusher at the shop, I don't know who made it but I know it was expensive. It works great and takes less than 5 minutes on most sights. Plus, all the parts that touch the gun are made of polymer...maybe delrin but I dont know...so there are never any marks on the slides. I'd be a bit apprehensive about a hammer and punch, esp. if the sights are hydraulically pressed in at the factory, like the springfield XD sights...good luck getting those out without screwing up your slide.
__________________
.308 Remington 700 SPSV - AICS - Nightforce - 168g SMK Handloads
1/2 MOA
.223 Remington 700 VS - 55gr VMAX Handloads
Sub-1/2 MOA
|