View Single Post
Old January 3, 2020, 10:10 AM   #3
Deltadart
Member
 
Join Date: April 26, 2015
Location: Washington State
Posts: 75
Thank you Scorch.
That is very valuable information and advise. I probably would have damaged the mounting screws by trying the punch / hammer method. I have the sight calculation formula and it will not take much of an increase in height. Do you know if there are any hoods that are a little higher than the factory supplied one on that rifle. I would like very much to keep the original appearance as possible.
Thank you
Paul
Deltadart is offline  
 
Page generated in 0.02967 seconds with 8 queries