View Single Post
Old March 3, 2013, 01:10 PM   #9
BerdanSS
Senior Member
 
Join Date: April 3, 2011
Location: to close to other houses
Posts: 1,176
Well after doing a mock up of the reaper mount with an extra PRI rail section I had....I fount it to be a complete PITA to remove a primer with a one piece base/ring setup. And as SSA said, I believe the scope I decided on wouldn't fit in the mount.

So I opted for the Durasight Z2s. They are two solid bolt on ring/mounts for a 1" tube and were made for the CVA. They'er pretty nice and well made for $25. And they match the color I did on the barrel to boot.

BerdanSS is offline  
 
Page generated in 0.03783 seconds with 8 queries