The Firing Line Forums - View Single Post - My new Windicator 4" nickel 357mag vs 686 vs Python

wild cat mccane · November 15, 2022, 11:25 AM

No.

If it's press, I would avoid. I'm pretty much done with "press" these days. After finding that the Python is build to be a bad trigger by the only factory approved gunsmith stating this, I'd never read that and bought the Python based on gun mag reviews. Never again.

My experience with the flagship M66 has been a lot of purchased guns over a long time. All ended up with cylinder binding and/or transfer bar failure.

The executive will only be a finish. It's not parts. So I'd avoid just on that fact if the "press" is anything other than finish.

November 15, 2022, 11:25 AM	#5
wild cat mccane Senior Member Join Date: May 22, 2011 Posts: 3,626	No. If it's press, I would avoid. I'm pretty much done with "press" these days. After finding that the Python is build to be a bad trigger by the only factory approved gunsmith stating this, I'd never read that and bought the Python based on gun mag reviews. Never again. My experience with the flagship M66 has been a lot of purchased guns over a long time. All ended up with cylinder binding and/or transfer bar failure. The executive will only be a finish. It's not parts. So I'd avoid just on that fact if the "press" is anything other than finish. __________________ My wife is a pulmonologist (respiratory Dr) and epidemiologist. If you have any questions on COVID, please reach out to me in PM.