View Single Post
Old January 9, 2013, 12:56 PM   #8
Senior Member
Join Date: December 5, 2009
Location: Frisco Texas
Posts: 844
If you are handy, lightly polish the chamber.

I used a dowel rod in a drill. I used masking tape and tightly wrapped the end to closely match the chamber size (use a bullet as a model)

I then used a car polish on the tape and used the drill for 30 seconds to polish

it cleaned the same issue up on both my and my friends new AR
An imperfect servant of my Lord and Saviour, Jesus

Buying American made, wherever I still can
dean1818 is offline  
Page generated in 0.03127 seconds with 8 queries