View Single Post
Old March 23, 2020, 12:14 PM   #39
Swifty Morgan
Senior Member
 
Join Date: September 13, 2018
Location: FL
Posts: 456
My plan is to hang the gongs from 1" by 1/8" bar, not chain. I'll have little bits of pipe over the horizontal member that supports all the gongs. The 1/8" bar will be welded to the bits of pipe, extending down. Bolts will attach the ends of the flat bar to the gongs. The bolts will be an inch or two longer than necessary, to make the gongs angle toward the ground a little.

The idea is to let the gongs swing backward and forward but not from side to side, which would be annoying.

So...any dire predictions regarding the design?
__________________
Humor-deafness is very real. Help fund research today.
Swifty Morgan is offline  
 
Page generated in 0.02825 seconds with 8 queries