The Firing Line Forums - View Single Post

BigEglockman · February 21, 2013, 01:18 PM

Thanks for the reply, sorry I will try to make it so everyone can read it next

post. Didn't think finding supplies was going to be this tough. Lee molds in 40

are hard to find. Can't wait till tax season is over and the supplies go back out.

So I think a .401 mold is what everyone casts to, then resizes from there. I will

Measure my barel width again to make sure this is going to work.

February 21, 2013, 01:18 PM	#7
BigEglockman Junior Member Join Date: February 20, 2013 Posts: 4	Thanks for the reply, sorry I will try to make it so everyone can read it next post. Didn't think finding supplies was going to be this tough. Lee molds in 40 are hard to find. Can't wait till tax season is over and the supplies go back out. So I think a .401 mold is what everyone casts to, then resizes from there. I will Measure my barel width again to make sure this is going to work.