The Firing Line Forums - View Single Post - hammer not lining up with cylinder cutout

Beagle333 · January 18, 2012, 09:50 PM

Well, that's easy enough to check. I never considered that. Let me bang the wedge out of a different '60 and try that cylinder.

Yes, it does it with 3 more Pietta cylinders. They all lock in good, but to the right of center of hammer. Left side, flush with hammer slot in frame and on right side, a little past the slot in frame. Can't measure it yet, caliper still in mail.

January 18, 2012, 09:50 PM	#7
Beagle333 Senior Member Join Date: January 7, 2012 Location: Auburn, AL. Posts: 2,332	Well, that's easy enough to check. I never considered that. Let me bang the wedge out of a different '60 and try that cylinder. Yes, it does it with 3 more Pietta cylinders. They all lock in good, but to the right of center of hammer. Left side, flush with hammer slot in frame and on right side, a little past the slot in frame. Can't measure it yet, caliper still in mail. Last edited by Beagle333; January 18, 2012 at 10:09 PM. Reason: checked it