Thread
:
Problem seating/crimping 9mm on a Hornady LnL
View Single Post
September 4, 2005, 07:02 PM
#
17
artbyaccident
Member
Join Date: July 5, 2005
Location: oregon
Posts: 19
now with the center of the die backed out all the way turn down the die until it just touches the case the maybe back it off 1/4 turn. Now lower the center of the die until it touches the bullet (just the center you dont want to touch the case yet) now press the bullet in a little at a time until you have the correct over all case legnth
now back out the center of the die all the way again
and lower the outside of the die to the case until it touches
artbyaccident
View Public Profile
Find More Posts by artbyaccident
Page generated in
0.02572
seconds with
8
queries