Quote:
Dave T Wrote:
Look at the un-even thickness of the OP's trigger guard in the last picture above, then tell me about Ruger's quality control.
|
I think that is a trick of the eye. You are looking at the flat edge and not accounting for the internal/external radius that is towards the front of the guard.
In the picture you referenced, look at the flat just below the trigger. Now follow it towards the front, you can see where they started the radius. Now look at the picture above it. Look at the interior of the trigger guard and follow it towards the barrel again. See what looks like a shadow in the inside? that is actually the bottom of the radius. Now, follow it again and account for that radius and you will see it is the same thickness all the way around. I imagine they do that for comfort.