The Firing Line Forums - View Single Post

Fire_Moose · February 19, 2013, 05:06 PM

Well right now I'm in the process of working up loads while fire forming brass. I had to pull a few bullets last night that I sat too deep. When trying to redo them, I noticed the bullets were slipping in a little too easy.

I have not set up my neck sizer yet (Lee collet) but I noticed the details capping pin seems to be needed to work.

Is there a way to neck size without ejecting a good primer?

February 19, 2013, 05:06 PM	#1
Fire_Moose Senior Member Join Date: January 16, 2013 Posts: 211	Whoops! (Neck sizing) Well right now I'm in the process of working up loads while fire forming brass. I had to pull a few bullets last night that I sat too deep. When trying to redo them, I noticed the bullets were slipping in a little too easy. I have not set up my neck sizer yet (Lee collet) but I noticed the details capping pin seems to be needed to work. Is there a way to neck size without ejecting a good primer?