View Single Post
Old August 5, 2022, 04:06 PM   #19
higgite
Senior Member
 
Join Date: October 21, 2010
Posts: 989
Quote:
Originally Posted by cdoc42 View Post
Is it reasonable to set the taper crimp die for the smallest case, i.e., 0.670? Will that make the crimp even tighter on cases in the 0.675 + range? Will it create pressure concerns?
I do that all the time (since I learned) with 9mm and 45ACP. Just don't go crazy with it if you're using lead or plated bullets. I have scraped a little plating off of plated bullets, but not enough to be an issue. I've had no issues at all with jacketed bullets.
higgite is offline  
 
Page generated in 0.05228 seconds with 8 queries