View Single Post
Old August 3, 2022, 12:57 AM   #2
rc
Senior Member
 
Join Date: April 28, 2001
Location: CA
Posts: 1,417
I have two suggestions since those are reloads. Bump your overall length down a bit to match typical factory length and check to make sure you get full length sizing with no buldge left near the base of the case. Your gun may swell the cases due to weak springs or large chamber and you sizing die is not able to get them down to spec to be reliable.
rc is offline  
 
Page generated in 0.05466 seconds with 8 queries