View Single Post
Old December 5, 2009, 11:55 AM   #5
Senior Member
Join Date: September 8, 2008
Location: NW Wash State
Posts: 216
Maybe its the prepping

I use the RCBS electric case prepping machine that has 5 rotating stations.
One for deburring outside and one for deburring the inside. I have noticed that this will leave more of and "edge" on the case then if I do it by hand.
This is only on the very edge of the case neck.
Could this b causing the splits?
Lilswede1 is offline  
Page generated in 0.03342 seconds with 8 queries