The Firing Line Forums - View Single Post

PetahW · August 4, 2013, 10:06 AM

.

I would just punch/drift the pin out.

Pins are usually pretty stout, but if you somehow damage it beyond use, it can be replaced by any appropriately-sized drill bit shank, ground to length.

.

August 4, 2013, 10:06 AM	#2
PetahW Senior Member Join Date: September 19, 2008 Posts: 4,678	. I would just punch/drift the pin out. Pins are usually pretty stout, but if you somehow damage it beyond use, it can be replaced by any appropriately-sized drill bit shank, ground to length. .