View Single Post
Old April 19, 2009, 06:17 PM   #4
circuit rider
Junior Member
 
Join Date: May 29, 2005
Location: E. Tn.
Posts: 11
Shooting Rest

May not have been on this forum, can't remember for sure, but a couple of years ago I was inquiring about a good, reasonably priced rest. Most that responded said if they could have only one it would be a Cowan. They are made in Altoona, Pa. in a Vo-Tech type school. Joe Cowan is the instructor. At that time someone gave me his email address. I contacted him and purchased one for $210.00 plus shipping. I'm not a competition shooter, but wanted a quality rest for my FNA1 SPR(308). I couldn't be more pleased. Hope this helps, Circuit Rider
circuit rider is offline  
 
Page generated in 0.02566 seconds with 8 queries