The Firing Line Forums - View Single Post - How to replace bulged barrel on Bersa Thunder 380

sidewindr · October 20, 2012, 02:23 PM

Now all you have to do is sand the bulge off the outside of the barrel so it clears the slide good, spray paint, and put it back together, Good as new !!

Think about it, there are many bubbas out there that would do just that and say no harm was done to the gun, then trade it in so someone else gets a "good deal" .

October 20, 2012, 02:23 PM	#19
sidewindr Senior Member Join Date: June 4, 2011 Location: somewhere out there Posts: 101	Now all you have to do is sand the bulge off the outside of the barrel so it clears the slide good, spray paint, and put it back together, Good as new !! Think about it, there are many bubbas out there that would do just that and say no harm was done to the gun, then trade it in so someone else gets a "good deal" .