When using the Lee flare die, set it so the bottom edge of the bullet juuuuuust clears the case mouth edge --- no more.
Since it's tube fed -- and with the die screwed off case mouth contact by a full turn......
- Set the seating stem to seat the bullet at/near the top of the crimp groove
- Back off the seating stem a couple of turns
- Then screw the die down to set your crimp into the groove as you desire (1/2-3/2 turn past contact).
- Screw down the seat stem to meet the bullet -- and lock the lock ring,
You can now seat; de-flare; and crimp in one step from that point on.
.
Last edited by mehavey; March 21, 2018 at 12:14 PM.
|