neck-sizing problem....
I have a Rem. 700 that was re-barreled (by a very good gunsmith) with a Shilen barrel to .25-06. After getting it back I fired several boxes of factory rounds, and then reloaded them using an RCBS neck-sizing die. I have always preferred neck-sizing, but have used full-length dies and just backed them out a small amount.
Now, I find that it is hard to close the bolt on them and it seems as if the shoulder dimension is too long. Since they are once-fired in the same rifle I find this mysterious. Factory rounds still chamber just fine.
Any help in solving this would be much appreciated. FYI: I have been re-loading since the 1960s, for rifle, pistol and shotgun. Is there something obvious that I am missing?
Murad, in Maine
|