View Single Post
Old January 30, 1999, 12:00 PM   #7
Spectre
Staff Alumnus
 
Join Date: October 23, 1998
Location: ATL
Posts: 3,277
Add a light coating of moly-loaded grease onto the action bars (think that's what they're called). You should notice an immediate difference. A quick run-over with some small-grit sandpaper or Dremel tool with jeweler's rouge before that certainly could only help, as well.

Moly grease can be purchased at any hardware store or large retail outlet such as K or Wal-Malmart. It provides better long-term protection between moving parts, especially if you are using a gun with a steel slide and aluminum frame. I use it on the slide rails of my pistols, and underneath the bolt rails on my SKS, as well as on the afore-mentioned bars of my M500.
Spectre is offline  
 
Page generated in 0.03229 seconds with 8 queries