[daddySEAL]

OK, thanks for the half staff info, I may have done that when the turret did not end in the lined up position on a die.

I've had this problem for a month now, only having been reloading in earnest that long after having the press for years (until I recently retired).
Even without the index bar in...and hand turning, I've noticed a "difficult spot" in the turret rotation at a certain place.

I have 5 turrets now for different caliber dies...and is there is the same problem for each turret. It has baffled me.

I called Lee, who said to send in the whole press, which I'm not wanting to do...and be "dead in the water" for reloading at all 'til it comes back.

I've been needing another turret anyway, so yesterday I ordered a 3 hole to 4 hole conversion "kit", like shown below...plus a new square plastic "ratchet". Then I will see if the new turret holder works more fluidly thru all stations.
I'm also going to use graphite on all moving parts.

Any thoughts?