View Single Post
Old December 14, 2019, 08:56 AM   #58
mehavey
Senior Member
 
Join Date: June 17, 2010
Location: Virginia
Posts: 5,581
When the die is screwed in/down to just clear the ram, the first bullet actually clears the sizing section/goes loose inside the middle of the die when pushed through. Second bullet sees no resistance from it at all.

Use/rub the "barest bit" of case lube/ Imperial wax on your thumb/forefinger as you pick the bullets up to size them.
mehavey is offline  
 
Page generated in 0.02657 seconds with 8 queries