[IllinoisCoyoteHunter]

If those are dropping from the mold that big then I would use one of those to slug your bore. I like to spray the inside of the barrel with gun oil and wipe a touch of boolit lube on the bearing surface of the bullet. Then whack it thru with a wood dowel rod or brass cleaning rod (I have a brass rod devoted to this because the threads got snapped off and can't use it for anything else).

You will be able to tell if the barrel sized the boolit down completely because the area that is sized will be shiny. Just make sure that when you slug your bore that the barrel is indeed sizing the boolit down to get an accurate measurement.

Good luck and those boolits look great!