View Single Post
Old June 4, 2012, 09:06 PM   #5
James K
Staff
 
Join Date: March 17, 1999
Posts: 24,193
I will vote for a cylinder notch that is a bit narrow or that has been battered a bit and is too narrow to accept the bolt.

I usually corrected that using a pattern makers file, but I never had to do it with a Python. It is not a hard job or difficult, but VERY prone to having the file slip and scatch the cylinder, not a nice thing with a Python. It helps to cover all but the tiny area you are working on with a couple of layers of Scotch tape.

Jim
__________________
Jim K
James K is offline  
 
Page generated in 0.03275 seconds with 8 queries