View Single Post
Old March 30, 2011, 11:56 AM   #2
CavScout1
Junior Member
 
Join Date: March 25, 2011
Posts: 4
Well I figured it out finally. The trigger guard which holds all the little complicated doo dads was worn. The trigger guard appers to be made out of pewter or some poor quality metal. Any how the area where the slide lock rests and moves was worn. This allowed the slide lock to travel further than intended causing the slide lock spring to not catch on the hammer when fired. The gun is only worth 70 bucks or so according to some blue book refrences. So instead of ordering a 50$ part+shipping I just busted out some good ole' JB weld. I actually think that the JB Weld I remolded with is stronger than the factory trigger guard. Any how it functions as it should. We'll see how long my "hillbilly engineering" last though.
CavScout1 is offline  
 
Page generated in 0.03244 seconds with 8 queries